Progressive-turf-equipment TDR-30 Manual de usuario

OPERATOR’S MANUAL AND PARTS LIST PROGRESSIVE TDR-30 TRI-DECK ROLLER FINISHING MOWER SERIAL NO: 13301002 AND UP PROGRESS

9 CAUTION! – Hazards or unsafe practices that COULD result in minor personal injury or product or property damage. GENERAL SAFETY PRECAUTIONS 

10  Power unit must be equipped with a 1-3/8” 6 spline 540 RPM PTO connection. Never use PTO adapters to connect implements. Never connect mo

11  Do not use the mower in limited visibility (e.g. at dusk, in fog, heavy rain etc.). Mow only in daylight or good artificial light.  Disen

12  Inspect tires daily for wear or damage. Check tire pressures weekly with an accurate pressure gauge. Do not inflate tires beyond 35 psi. 

13 SAFETY & MAINTENANCE DECAL LOCATIONS ON MACHINE ITEM NO. DESCRIPTION QTY ITEM NO. DESCRIPTION QTY 1 DANGER – READ MANUAL 1 10 NOT

14 SAFETY DECAL IDENTIFICATION  If decals become faded, damaged, or lost, replace immediately. Order Decal Kit, Part # 607080. Safety Decals sh

15 GREASE POINT DECAL (521014) ITEM 14 (210238) ITEM 15

16 ASSEMBLY INSTRUCTIONS SET-UP The mower is shipped in 3 main assemblies in order to facilitate shipping within enclosed vans. Approximately

17 WING DECK INSTALLATION 2. With the TDR Spreader Fixture (526498) in place, attach a ratchet equipped strap between both wing decks using th

18 6. Lower the wing until the deck swivel mounting points align with the bushings on the wing deck. Re-install the painted 1-1/4” pins through

19 3. Each outer deck assembly has the opposite wing installed on it upon shipment. Each outer wing frame must be removed and installed on the c

20 8. Place the LH wing onto the LH deck by aligning each tie rod with its corresponding mount point. 9. Remove the 5/8” x 6

21 10. Align the corresponding tie rod end of the wing with the mounting brackets and reinstall the hardware as shown. 11. Attach th

22 13. Move the Outer Wing Deck towards the main wing deck until they contact the front and rear plastic bumpers on the wing deck. Align the ou

23 16. Cut all plastic ties securing the wing stop rod. Remove the 5/8” hex bolt and lock nut from the upright brackets on the Outer Wing and fas

24 INSTALLING DECK PTO SHAFTS The three identical PTO shafts are used to drive the mower decks. Each PTO shaft will have one end designated a t

25 2. Connect the outer PTO guard chains to the locations shown. TIRES Upon receiving your mower, check air pressure in the tires and adjust

26 HITCHING MOWER TO TRACTOR Attach mower to drawbar only. DRAWBAR SETUP  Drawbar should be adjusted so it is 14” to 15” fro

27 POWER TAKE-OFF Keep all safety shields in place. When operating the power take-off, be sure the tractor shield is always in place, co

28 CONNECTING THE INPUT PTO SHAFT a) Ensure that the tractor engine is shut off and the parking brake is locked. b) Holding the PTO against t

2 TABLE OF CONTENTS PAGE TO THE OWNER ... 4 HAZARD SER

29 CHECK PTO LENGTH & HITCH INTERFERENCE DURING TURNS During the mowing operation the tractor should be able to make turns withou

30 HYDRAULIC CONNECTION TO TRACTOR Hydraulic fluid escaping under pressure can penetrate the skin causing serious injury. If skin pe

31 OPERATING THE MOWER A careful and knowledgeable operator is the best insurance against an accident. Allow no riders on any equipment. Always

32 LOWERING THE DECKS Before lowering the decks, make sure that there are no obstacles or people in the area that the decks could come in contact

33 PRO LIFT-N-TURN™ OPERATION The industry exclusive Pro Lift-N-Turn™ system found on the TDR-30 mower offers a real productivity adva

34 CUTTING HEIGHT ADJUSTMENT There are four height adjusters per mowing deck. Each adjuster (located in each corner of the deck) must be adjust

35 TRANSPORTING MOWERS Always adhere to local department of transportation laws when transporting equipment on local roadways. When traveling

36 1 2 3 4 LOCK PIN POSITIONS The wing and rear locks (black plates) can be held in place by using the supplied pin. The holes in the lock mo

37 MAINTENANCE Turn tractor engine off before performing any maintenance. Always use personal protection devices such as eye and ear p

38 PRO LIFT-N-TURN™ SYSTEM MAINTENANCE As with any mechanical system, the Pro Lift-N-Turn™ system needs to be used and maintained properly. Wit

3

39 GEAR BOX OIL LEVELS IMPORTANT! DO NOT OVERFILL! MOWER MUST BE LEVEL WHEN CHECKING GEAR BOX OIL LEVEL DECK GEAR BOXES Gear boxes all have a

40 FASTENERS INSTALLATION TORQUE The chart lists the correct tightening torque for fasteners on Progressive Turf Equipment mowers. W

41 BLADE SERVICING Be sure safety locks are in place when working on decks in the raised position. The tractor hydraulic system could fail, ca

42 SPINDLE SERVICE Spindles are equipped with two roller ball bearings. Adjustment is set by tightening the 1” left hand nut to 6

43 SPINDLE REASSEMBLY Only use a press that has the ram and bed 100% square to each other. If bearings are not square in housing, bearings wil

44 “V” BELT ADJUSTMENT Each mower deck is equipped with 2 spindle drive belts, each with a dedicated draw-type screw tensioner. To adjust bel

45 HYDRAULICS The hydraulic system on your Progressive mower is a simple cylinder system used to raise and lower the cutting decks into posit

46 TROUBLESHOOTING PROBLEM CAUSE REMEDY Belt Slippage Lack of Tension Oily Drive Conditions Increase Tension Clean up Drive Rapid Belt

47 NOTES

Parts Manual TDR-30 TDR 30 Effective serial number: 13301004 and up. 19/10/2014 Si No Lee Ingles, Pida Ayuda a Alguien Que Se Lo Lea Para Que

4 TO THE OWNER Before you operate this mower, study this manual carefully. It has been prepared to help you do a better and safer job of main

Serial Number Location The serial number plate for the machine is located on the left side of the main frame tube at the front For quick reference,

TDR 30 Parts Manual Maintenance Maintenance should always be performed by a qualified service technician familiar with servicing similar equipment,

PARTS ORDERING GUIDE The following instructions are offered to help eliminate needless delay and error in processing purchase orders for the equipm

TDR 30 Parts Manual 5 Table of Contents SERIAL NUMBER LOCATION...

TDR 30 Parts Manual 6 1 DECK ASSEMBLY 1.1 Blade Spindle Assembly 02/2015

TDR 30 Parts Manual 7 1.2 Blade Options

TDR 30 Parts Manual 8 1.3 Wing Deck Gearbox Assembly 02/2015

TDR 30 Parts Manual 9 1.4 Outer Wing Deck Gearbox Assembly 02/2015

TDR 30 Parts Manual 10 1.5 Rear Deck Gearbox Assembly 02/2015

TDR 30 Parts Manual 11 1.6 Wing Deck Assembly – L.H. 02/2015

5 GENERAL INFORMATION The purpose of this manual is to assist the operator in maintaining and operating Progressive Turf Equipment mowers. R

TDR 30 Parts Manual 12 1.7 Wing Deck Assembly – R.H. 02/2015

TDR 30 Parts Manual 13 1.8 Wing Deck Guarding 02/2015

TDR 30 Parts Manual 14 1.9 Outer Wing Deck Assembly 05/2015

TDR 30 Parts Manual 15 1.10 Outer Wing Deck Guarding 02/2015

TDR 30 Parts Manual 16 1.11 Wing Deck Height Adjustment 02/2015

TDR 30 Parts Manual 17 1.12 Rear Deck Assembly 02/2015

TDR 30 Parts Manual 18 1.13 Belt Drive Assembly – Wing 02/2015

TDR 30 Parts Manual 19 1.14 Belt Drive Assembly – Rear 02/2015

TDR 30 Parts Manual 20 2 FRAME ASSEMBLY 2.1 Frame Assembly 02/2015

TDR 30 Parts Manual 21 2.2 Wing Lift Assembly 02/2015

6

TDR 30 Parts Manual 22 2.3 Outer Wing Frame Assembly – LH 03/2015

TDR 30 Parts Manual 23 2.4 Outer Wing Frame Assembly – RH 03/2015

TDR 30 Parts Manual 24 2.5 Outer Wing Lift Assembly – LH & RH 05/2015

TDR 30 Parts Manual 25 2.6 Rear Lift Assembly 02/2015

TDR 30 Parts Manual 26 2.7 Wheel Assemblies 02/2015

TDR 30 Parts Manual 27 3 HYDRAULICS 3.1 Hydraulics – Up to Serial #14301009

TDR 30 Parts Manual 28 3.2 Hydraulics – Serial #15301011 & up 05/2015

TDR 30 Parts Manual 29 4 DRIVELINE 4.1 Driveline 02/2015

TDR 30 Parts Manual 30 4.2 Input PTO Shaft 02/2015

TDR 30 Parts Manual 31 4.3 Intermediate PTO Shaft 02/2015

7 TDR-30 MACHINE SPECIFICATIONS Cutting Width 30 feet Cutting Height 1/2” to 4” Deck Flexibility 25” up, 15 degree down Recommended HP 85 Min

TDR 30 Parts Manual 32 4.4 Wing Deck PTO Shaft 02/2015

TDR 30 Parts Manual 33 4.5 Outer Wing Deck PTO Shaft 02/2015

TDR 30 Parts Manual 34 4.6 Wing Deck Gearbox 02/2015

TDR 30 Parts Manual 35 4.7 Outer Wing Deck Gearbox 02/2015

TDR 30 Parts Manual 36 4.8 Rear Deck Gearbox 02/2015

TDR 30 Parts Manual 37 4.9 4 Way Gearbox 02/2015

TDR 30 Parts Manual 38 5 DECALS 5.1 Safety If decals become faded, damaged, or lost, replace immediately. Order Decal Kit, Part # 522002

TDR 30 Parts Manual 39 209179 DECAL – TDR 30 526001 100HR DECAL – PTO GREASE 526003 DECAL – GREASING SCHEDULE 521014 DECAL – GREASE GUN 521455 DE

TDR 30 Parts Manual 40 5.2 General Info

8 SAFETY RULES All rotary mowers are potentially dangerous machines; this mower has been designed to minimize the safety risks to