Progressive-turf-equipment TDR-22 1393176 and Above Manual de usuario

OPERATOR’S MANUAL AND PARTS LIST PROGRESSIVE TDR-22 TRI-DECK ROLLER FINISHING MOWER SERIAL NO: 1393176 AND UP PROGRE

7 TDR-22 MACHINE SPECIFICATIONS Cutting Width 22 feet Cutting Height 1/2” to 4” Deck Flexibility 25” up, 15 degree down Recommended HP 65 Min

8 SAFETY RULES All rotary mowers are potentially dangerous machines; this mower has been designed to minimize the safety risks to the opera

9 CAUTION! – Hazards or unsafe practices that COULD result in minor personal injury or product or property damage. GENERAL SAFETY PRECAUTIONS 

10  Power unit must be equipped with a 1-3/8” 6 spline 540 RPM PTO connection. Never use PTO adapters to connect implements. Never connect mo

11  Do not use the mower in limited visibility (e.g. at dusk, in fog, heavy rain etc.). Mow only in daylight or good artificial light.  Disen

12  Inspect tires daily for wear or damage. Check tire pressures weekly with an accurate pressure gauge. Do not inflate tires beyond 35 psi. 

13 SAFETY & MAINTENANCE DECAL LOCATIONS ON MACHINE ITEM NO. DESCRIPTION QTY ITEM NO. DESCRIPTION QTY 1 DANGER – READ MANUAL 1 11 MOW

14 SAFETY DECAL IDENTIFICATION  If decals become faded, damaged, or lost, replace immediately. Order Decal Kit, Part # 526012. Safety Decals sh

15 GREASE POINT DECAL (521014) ITEM 16 (210238) ITEM 13

16 ASSEMBLY INSTRUCTIONS SET-UP The mower is shipped in a 90% assembled condition to facilitate shipping of the mower in enclosed vans. Approxima

17 WING DECK INSTALLATION 2. With the TDR Spreader Fixture (526498) in place, attach a ratchet equipped strap between both wing decks using the

18 6. Lower the wing until the deck swivel mounting points align with the bushings on the wing deck swivel. Re-install the painted 1-1/4” pins t

19 HITCHING MOWER TO TRACTOR Attach mower to drawbar only. DRAWBAR SETUP  Drawbar should be adjusted so it is 14” to 15” fro

20 POWER TAKE-OFF Keep all safety shields in place. When operating the power take-off, be sure the tractor shield is always in place, cover

21 CONNECTING THE INPUT PTO SHAFT a) Ensure that the tractor engine is shut off and the parking brake is locked. b) Holding the PTO against the

22 CHECK PTO LENGTH DURING TURNS During the mowing operation the tractor should be able to make turns without damage to the driveline. To ensure

23 HYDRAULIC CONNECTION TO TRACTOR Hydraulic fluid escaping under pressure can penetrate the skin causing serious injury. If skin penetration o

24 OPERATING THE MOWER A careful and knowledgeable operator is the best insurance against an accident. Allow no riders on any equipment. Alw

25 LOWERING THE DECKS Before lowering the decks, make sure that there are no obstacles or people in the area that the decks could come in contact

26 CUTTING HEIGHT ADJUSTMENT There are four height adjusters per mowing deck. Each adjuster (located in each corner of the deck) must be adjust

DECLARATION OF CONFORMITY According to Annex 11 A of the European Community Regulation for Machines We, Progressive Turf Equipment Inc. 137 W

27 PRO LIFT-N-TURNTM OPERATION The industry exclusive Pro Lift-N-Turn™ system found on certain Progressive Turf Equipment models offers a

28 1 2 3 4 CAUTION: If the Pro Lift-N-Turn™ system is actuated with the PTO running, and any of the latch plates are not in the cor

29

30 TRANSPORTING MOWERS When traveling on public roadways, use flashing amber lights and S.M.V. emblem on rear of mower to provide greater vis

31 MAINTENANCE Turn tractor engine off before performing any maintenance. Always use personal protection devices such as eye and ear

32 GREASING A properly maintained lubrication schedule will provide a smooth running machine for many years. All pivot locations have gr

33 GEAR BOX OIL LEVELS IMPORTANT! DO NOT OVERFILL! MOWER MUST BE LEVEL WHEN CHECKING GEAR BOX OIL LEVEL DECK GEAR BOXES Gear boxes all have a

34 FASTENERS INSTALLATION TORQUE The chart lists the correct tightening torque for fasteners on Progressive Turf Equipment mowers.

35 BLADE SERVICING Be sure safety locks are in place when working on decks in the raised position. The tractor hydraulic system could fail, ca

36 Follow original sharpening pattern as shown. Sharpen blade to a razor edge. Protect hands when sharpening. Do not sharpen ba

37 SPINDLE REASSEMBLY Only use a press that has the ram and bed 100% square to each other. If bearings are not square in housing, bearings wil

38 “V” BELT ADJUSTMENT Each mower deck is equipped with 2 spindle drive belts, each with a dedicated draw-type screw tensioner. To adjust belt

39 HYDRAULICS The hydraulic system on your Progressive mower is a simple cylinder system used to raise and lower the cutting decks into positio

40 TROUBLESHOOTING PROBLEM CAUSE REMEDY Belt Slippage Lack of Tension Oily Drive Conditions Increase Tension Clean up Drive Rapid Belt

41 NOTES

Parts List TDR-22 Effective serial number: 1393176 and up. P.N. 120517 Issue Date: October 2014 Si No Lee Ingles, Pida Ayuda a Alguien Que Se

Serial Number Location The serial number plate for the machine is located on the left side of the main frame tube at the front of the machine. For q

TDR-22 Parts Manual Maintenance Maintenance should always be performed by a qualified service technician familiar with servicing similar equipment,

PARTS ORDERING GUIDE The following instructions are offered to help eliminate needless delay and error in processing purchase orders for the equipm

Table of Contents SERIAL NUMBER LOCATION...

2 TABLE OF CONTENTS PAGE TO THE OWNER ...

TDR-22 Parts Manual 1 1 DECK ASSEMBLY 1.1 Blade Spindle Assembly 12/2014

TDR-22 Parts Manual 2 1.2 Blade Options

TDR-22 Parts Manual 3 1.3 Wing Deck Gear Box Mount 12/2014

TDR-22 Parts Manual 4 1.4 Rear Deck Gear Box Mount Assembly

TDR-22 Parts Manual 5 1.5 Deck Assembly 02/2015

TDR-22 Parts Manual 6 1.6 Deck Shields 12/2014

TDR-22 Parts Manual 7 1.7 Wing Deck Drive 12/2014

TDR-22 Parts Manual 8 1.8 Rear Deck Drive 12/2014

TDR-22 Parts Manual 9 2 Frame Assembly 2.1 Frame Assembly 12/2014

3

TDR-22 Parts Manual 10 2.2 Left Wing Assembly 12/2014

TDR-22 Parts Manual 11 2.3 Right Wing Assembly 12/2014

TDR-22 Parts Manual 12 2.4 Rear Lift Assembly 12/2014

TDR-22 Parts Manual 13 2.5 Wheel Assemblies 12/2014

TDR-22 Parts Manual 14 2.6 Optional Wheel Assemblies – High Flotation (Option)* *NOTE: TO UPGRADE TO HIGH FLOTATION TIRES (230057), NEW AXLE ASSEMBLI

TDR-22 Parts Manual 15 3 HYDRAULICS 3.1 Hydraulics 02/2015

TDR-22 Parts Manual 16 4 DRIVELINE 4.1 Driveline 12/2014

TDR-22 Parts Manual 17 4.2 Deck PTO Shaft 12/2014

TDR-22 Parts Manual 18 4.3 Intermediate PTO Shaft 12/2014

TDR-22 Parts Manual 19 4.4 Input PTO Shaft 12/2014

4 TO THE OWNER Before you operate this mower, study this manual carefully. It has been prepared to help you do a better and safer job of maint

TDR-22 Parts Manual 20 4.5 Deck Gearbox

TDR-22 Parts Manual 21 4.6 4-Way Gear Box

TDR-22 Parts Manual 22 5 Decals 5.1 Safety If decals become faded, damaged, or lost, replace immediately. Order decal according to correspo

TDR-22 Parts Manual 23 TDR-22 ROLLER MOWER 521119 8HR DECAL – PTO GREASE 526003 DECAL – GREASING SCHEDULE 209187 DECAL – TDR 22 ROLLER MOWER 52101

TDR-22 Parts Manual 24 5.2 General Info

5 GENERAL INFORMATION The purpose of this manual is to assist the operator in maintaining and operating Progressive Turf Equipment mowers. R

6