Progressive-turf-equipment Pro-Flex 120 14272040 And Above Manual de usuario

Operator’s Manual & Parts List Pro-Flex 120 Serial No. 14272040 and up Pro-Flex Roller 120 Serial No. 15101019 and up PROGRESSIV

Pro-Flex 120 Series Operator’s Manual 6 SPECIFICATIONS PRO-FLEX 120 Tractor Requirement Size ...

Pro-Flex 120 Series Operator’s Manual 7 PRO-FLEX ROLLER 120 Tractor Requirement Size ...

Pro-Flex 120 Series Operator’s Manual 8 COMPONENT IDENTIFICATION PRO-FLEX 120 NOTE: DECK BLADE ROATION DIRECTIONS NOTES 1) Throughout this man

Pro-Flex 120 Series Operator’s Manual 9 PRO-FLEX ROLLER 120 NOTE: DECK BLADE ROATION DIRECTIONS NOTES 1) Throughout this manual, references are

Pro-Flex 120 Series Operator’s Manual 10 SAFETY RULES All rotary mowers are potentially dangerous machines; this mower has been designed

Pro-Flex 120 Series Operator’s Manual 11 GENERAL SAFETY PRECAUTIONS  The operator of this machine must have sufficient knowledge and inst

Pro-Flex 120 Series Operator’s Manual 12  Hydraulic circuits to control mower functions must be set to 2000psi maximum working pressure.

Pro-Flex 120 Series Operator’s Manual 13  Ensure wing and deck safety locks are securely engaged before transporting mower with wings in r

Pro-Flex 120 Series Operator’s Manual 14 Do not support the machine on cinder blocks, hollow tiles or other members that may fail under co

Pro-Flex 120 Series Operator’s Manual 15 When servicing any hydraulic component of the mower ensure that all decks and wings are in their lowe

Pro-Flex 120 Series Operator’s Manual 16 SAFETY DECALS If decals become faded, damaged, or lost, replace immediately. Order Decal Kit, Part

Pro-Flex 120 Series Operator’s Manual 17 DECAL LISTING No. 1 - 209172 No. 2 - 209171 No. 5 - 209173 No. 3 - 209113 No. 4 - 521817 No. 8 - 526

Pro-Flex 120 Series Operator’s Manual 18 ASSEMBLY INSTRUCTIONS Mower assembly must be completed by a qualified technician using safe work

Pro-Flex 120 Series Operator’s Manual 19 MOWER SETUP FOR OPERATION Always refer to tractor operator’s manual for specific detailed informat

Pro-Flex 120 Series Operator’s Manual 20 swivel to hold it level while aligning the hitch. Do not operate mower with the hitch pin in the hitch swiv

Pro-Flex 120 Series Operator’s Manual 21 CONNECTING THE HYDRAULICS 1) Ensure the tractor controls are in the park position, the engine is turned of

Pro-Flex 120 Series Operator’s Manual 22 DECK SAFETY LOCK Each deck is provided with individual safety locks. These locks have (2) modes of operati

Pro-Flex 120 Series Operator’s Manual 23 CHECK PTO LENGTH - TURNING AND ON HILLS The Pro-Flex 120 mower is designed for mowing of uneven, c

Pro-Flex 120 Series Operator’s Manual 24 DISCONNECTING THE MOWER The mower can be stored with the wings/decks in the raised or lowered

Pro-Flex 120 Series Operator’s Manual 25 ADJUSTING THE MOWER FOR CUTTING Ensure safety locks are properly engaged before attempting to serv

DECLARATION OF CONFORMITY According to Annex 11 A of the European Community Regulation for Machines We, Progressive Turf Equipment Inc. 137

Pro-Flex 120 Series Operator’s Manual 26 On the pivoting arm side remove the two axle stop pins and the center pivot bolt. Reposition the axle to th

Pro-Flex 120 Series Operator’s Manual 27 5) Using a 9/16” wrench, loosen the lock bolt on each end of the roller arm adjusting quadrant. 6) Whil

Pro-Flex 120 Series Operator’s Manual 28 OPERATING THE MOWER DAILY CHECK LIST 1) Always wear relatively tight and belted clothing to avoid

Pro-Flex 120 Series Operator’s Manual 29 ENGAGING THE MOWER When engaging the mower, it is important to follow this procedure: 1) Lower the wings

Pro-Flex 120 Series Operator’s Manual 30 The mower blades remain at cutting speed while using the Pro Lift-N-TurnTM system. Do not proceed int

Pro-Flex 120 Series Operator’s Manual 31 CLEARING BLOCKAGES If a deck discharge chute becomes clogged during mowing: 1) Stop the tractor and set pa

Pro-Flex 120 Series Operator’s Manual 32 MAINTENANCE Ensure the tractor controls are in the park position, the engine is turned off, the parking br

Pro-Flex 120 Operator’s Manual 33 LUBRICATION A properly maintained lubrication schedule will provide a smooth running machine for many

Pro-Flex 120 Series Operator’s Manual 34 DRIVELINE GREASING All PTO shafts on the Pro-Flex 120 mower feature 100h greasing interval. The

Pro-Flex 120 Series Operator’s Manual 35 INTERMEDIATE BEARING – 40h / Weekly (1 Location) PIVOT LOCATIONS: 40h / Weekly Most pivot location

Pro-Flex 120 Series Operator’s Manual 36 GEARBOX OIL: Recommended Oil: SAE 90 EP or SAE 80W90 EP Factory Fill: Shell Spirax HD SAE 80W90 Checking

Pro-Flex 120 Series Operator’s Manual 37 “V” BELT DRIVE BELT TENSION - 100h / Monthly Proper belt tension is a fundamental factor in success

Pro-Flex 120 Series Operator’s Manual 38 BELT ROUTING FASTENER INSTALLATION TORQUE The chart below lists the proper installation torque for

Pro-Flex 120 Series Operator’s Manual 39 BLADE SERVICING Always observe proper lock-out procedures when performing any maintenance work i

Pro-Flex 120 Series Operator’s Manual 40 BLADE SHARPENING Use gloves when handling mower blades. Blades can be very sharp. IMPORTANT! Whe

Pro-Flex 120 Series Operator’s Manual 41 SPINDLE ASSEMBLY REPAIR Note: A video showing this rebuild procedure is available on our website: http://

Pro-Flex 120 Series Operator’s Manual 42 HYDRAULICS Hydraulic Oil – Conventional Anti-Wear Tractor-Hydraulic Fluid Biodegradable Oils – Consult Fact

Pro-Flex 120 Series Operator’s Manual 43 SUPPORTING MACHINE FOR SERVICE (2) Points are available to lift the mower off of the ground for servicing t

Pro-Flex 120 Series Operator’s Manual 44 TROUBLE SHOOTING PROBLEM CAUSE REMEDY Belt slippage Lack of tension Inspect & replace belt or t

Pro-Flex 120 Series Parts List Parts List Pro-Flex 120 Serial No. 14272040 and up Pro-Flex Roller 120 Serial No. 15101019 and up PROGRESSIVE T

Pro-Flex 120 Series Operator’s Manual TABLE OF CONTENTS PAGE INTRODUCTION ...

Pro-Flex 120 Series Parts List

Pro-Flex 120 Series Parts List 47 TABLE OF CONTENTS PAGE SERIAL NUMBER LOCATION ...

Pro-Flex 120 Series Parts List 48

Pro-Flex 120 Series Parts List 49 SERIAL NUMBER LOCATION The serial number plate for the machine is located on the left side of the main frame tube at

Pro-Flex 120 Series Parts List 50 MAINTENANCE Maintenance should always be performed by a qualified service technician familiar with servi

Pro-Flex 120 Series Parts List 51 1. DECK ASSEMBLY 1.1. BLADE SPINDLE ASSEMBLY – MAINTENANCE FREE 02/2015

Pro-Flex 120 Series Parts List 52 1.2. BLADE OPTIONS 11/2014

Pro-Flex 120 Series Parts List 53 1.3. DECK ASSEMBLY – PF-120 *Right rear deck shown; see Section 1.5 for other decks 05/2015 *AVAILABLE IN BOTH R

Pro-Flex 120 Series Parts List 54 1.4. DECK ASSEMBLY – PFR-120 *Right front deck shown; see Section 1.6 for other decks 11/2014

Pro-Flex 120 Series Parts List 55 1.5. DECK ARM ASSEMBLIES – PF-120 11/2014

Pro-Flex 120 Series Operator’s Manual 2 MAINTENANCE ...

Pro-Flex 120 Series Parts List 56 1.6. DECK ARM ASSEMBLIES – PFR-120 11/2014

Pro-Flex 120 Series Parts List 57 1.7. DRIVE BELTS 11/2014

Pro-Flex 120 Series Parts List 58 1.8. BELT DRIVE ASSEMBLY - LEFT 11/2014

Pro-Flex 120 Series Parts List 59 1.9. BELT DRIVE ASSEMBLY - RIGHT . 11/2014

Pro-Flex 120 Series Parts List 60 2. FRAME ASSEMBLY 2.1. FRAME ASSEMBLY - REAR 05/2015 *AVAILABLE IN BOTH RED & GREEN FINISHES. PART NUMBER SH

Pro-Flex 120 Series Parts List 61 2.2. FRAME ASSEMBLY - FRONT 05/2015 *AVAILABLE IN BOTH RED & GREEN FINISHES. PART NUMBER SHOWN IS FOR RED FI

Pro-Flex 120 Series Parts List 62 2.3. DECK LIFT ARM ASSEMBLIES 05/2015 *AVAILABLE IN BOTH RED & GREEN FINISHES. PART NUMBER SHOWN IS FOR RED

Pro-Flex 120 Series Parts List 63 3. HYDRAULICS 11/2014

Pro-Flex 120 Series Parts List 64 4. DRIVELINE 4.1. INPUT DRIVELINE 01/2015

Pro-Flex 120 Series Parts List 65 4.2. DRIVELINE GUARDING 11/2014

Pro-Flex 120 Series Operator’s Manual 3 INTRODUCTION Thank you for purchasing a Pro-Flex 120 mower. This product is designed and manufactured to all

Pro-Flex 120 Series Parts List 66 4.3. INPUT PTO SHAFT 11/2014

Pro-Flex 120 Series Parts List 67 4.4. INTERMEDIATE PTO SHAFT 11/2014

Pro-Flex 120 Series Parts List 68 4.5. GEARBOX 11/2014

Pro-Flex 120 Series Parts List 69 5. WHEEL ASSEMBLIES 5.1. WHEEL ASSEMBLIES 04/2015

Pro-Flex 120 Series Parts List 70 5.2. ROLLER ASSEMBLIES PF120R Only 11/2014

Pro-Flex 120 Series Parts List 71 6. SAFETY 6.1. DECALS 209150 PT209160 DECAL – RUN OVER / NO RIDERS PT209162 DECAL – HYD PRESSURE HAZARD PT209155

Pro-Flex 120 Series Parts List 72 209171 DECAL – PTO COLLAPSE - CV 210239 SAFETY SIGN – INNER GUARD 210237 SAFETY SIGN – OUTER GUARD 210238 CE WARNING

Pro-Flex 120 Series Parts List 73 209102 DECAL – “PRO-FLEX” 521014 DECAL – GREASE GUN 521014 DECAL – GREASE GUN 521784 DECAL - NOTICE 209103 DECAL

Pro-Flex 120 Series Parts List 74 6.2. NOTES

Pro-Flex 120 Series Operator’s Manual 4 OSHA Training Requirements (USA) The following training requirements have been taken from Title 29, Code of

Pro-Flex 120 Series Operator’s Manual 5 Modifications are officially approved if at least one of the following conditions is met: i. The attachment